|
X-10 PA011 SuperSocket - Wall Receptacle
Module
Control you lights or appliances from across the room or the other side
of the house.
- Get the
clean, finished look with SuperSocket!
- Appliance Module already built in!
X10 control on top, bottom outlet is always live! In areas
of your house that have high visibility, use X10 Wall Receptacles for a clean, finished
look.
The control components are built-in, so Lamp Modules are
not necessary.
Features a controlled outlet at the top of the receptacle,
the lower outlet is not controlled.
Both outlets are rated at 15 amps.
Responds to ON/OFF and ALL UNITS OFF, but not to ALL LIGHTS
ON or DIM/BRIGHT commands.
Controlled devices may still be turned off and on with
their own switches.
The Wall Receptacle Module is designed to control unrestricted loads up to
15Amp. It provides
two outlets, one X-10 controlled (upper) and one which is always on
(lower). A trim plate is
included to complete the installation.
Installing the Wall Receptacle Module
• Disconnect power at the circuit breaker.
• Remove the existing wall plate and unscrew the receptacle from its
box.
• Disconnect the wiring to the existing receptacle.
• Connect the black wire of the Wall Receptacle Module to Live, the
white wire to Neutral and the
green wire to ground (or the wall box) using the wire nuts provided. Refer
to the diagram
above.
• Refit the Wall Receptacle Module in the wall box and finish off
with the trim plate provided.
Setting up the Wall Receptacle Module
• Set the House Code dial to the same letter set on the controller or
Security Console. The House
Code for monitored security consoles is downloaded by the security
installation firm. The
default House Code is 'A', when used with the X-10 PRO2000.
• Set the Unit Code dial to an unused code which can be controlled
from the controller or an RF
remote such as the Security Remote, PSR01, (switches 1-4 control Unit
Codes 1-4 When used
with the X-10 PRO2000).
|
